EDAC/altera: Drop __init from ECC setup paths for re-probe safety
Linux
Affected versions
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
|
Linux
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
|
6.18.567.2.107.3In the Linux kernel, the following vulnerability has been resolved:
EDAC/altera: Drop __init from ECC setup paths for re-probe safety
Sashiko reports:
"Does suppressing sysfs unbinding fully prevent the execution of freed __init memory? If altr_sysmgr_regmap_lookup_by_phandle() returns -EPROBE_DEFER, the probe is deferred until after __init memory is freed."
The a10 EDAC .setup callbacks (sdmmc, ethernet, nand, dma, usb, qspi) and their helpers (altr_init_a10_ecc_device_type, altr_init_a10_ecc_block) were marked __init. These run from the probe path, which may execute after init memory is freed -- e.g. a probe deferred via -EPROBE_DEFER that only succeeds once a late/module dependency appears, or a manual unbind/rebind. Calling __init code then dereferences freed memory. Remove __init so these functions remain valid at runtime.
From the CVE record · Linux
Altera a10 EDAC setup callbacks and helpers were marked as init-only code, but the probe path can call them after init memory has been freed. A deferred probe or manual unbind and rebind can trigger this condition. The input does not describe an attacker path or authentication requirements.
Engineers running Linux kernels with Altera a10 EDAC support should check their kernel version; affected versions were not provided.