ASoC: fsl_audmix: rework runtime PM handling in probe
Linux
Affected versions
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
Linux
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
|
In the Linux kernel, the following vulnerability has been resolved:
ASoC: fsl_audmix: rework runtime PM handling in probe
After pm_runtime_enable() the AUDMIX block is powered off and stays suspended until the first runtime resume. Register writes issued between probe() and the first resume (e.g. from DAPM or ALSA control paths) target unpowered hardware and cause a system hang.
Fix this by calling pm_runtime_resume_and_get() immediately after pm_runtime_enable() to power the hardware up and enable its clocks. Release the reference afterwards with pm_runtime_put() to allow the runtime PM framework to suspend the device and switch the regmap to cache-only mode when idle.
When CONFIG_PM is disabled or runtime PM is not enabled, pm_runtime_* calls are stubs that do not power up the hardware. Handle this case explicitly by calling fsl_audmix_runtime_resume() directly so the hardware is always initialised and its clocks are enabled, ensuring register accesses succeed regardless of PM configuration.
From the CVE record · Linux
The Linux kernel’s fsl_audmix driver can access unpowered hardware during probe, causing a system hang. The input does not describe an attacker path or specify whether network access, authentication, or user interaction is required.
Engineers running Linux systems that use the fsl_audmix driver should check their kernel; affected versions are not specified.