usb: ljca: bound bank_num in ljca_enumerate_gpio()
Linux
Affected versions
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
Linux
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
|
In the Linux kernel, the following vulnerability has been resolved:
usb: ljca: bound bank_num in ljca_enumerate_gpio()
ljca_enumerate_gpio() reads desc->bank_num from the device and loops valid_pin[i] = get_unaligned_le32(...) for i < bank_num. valid_pin[] holds only LJCA_MAX_GPIO_NUM / 32 = 2 entries.
Two checks run before the loop. The reply length must match struct_size(desc, bank_desc, bank_num). The product pins_per_bank * bank_num must not exceed LJCA_MAX_GPIO_NUM. Neither one bounds bank_num against the size of valid_pin[]. The reply is capped at LJCA_MAX_PAYLOAD_SIZE (60) bytes, so the struct_size check limits bank_num to 9. A device that reports bank_num 9 with pins_per_bank 7 still passes both checks. gpio_num is 63 and the reply is 56 bytes. The loop then writes nine u32 into the two entry array and overruns valid_pin[] on the stack.
A broken or malicious LJCA device can therefore overflow the stack. Reject a bank_num that does not fit valid_pin[].
From the CVE record · Linux
The Linux kernel’s LJCA GPIO enumeration does not check whether a device-reported bank count fits a two-entry stack array. A broken or malicious LJCA device can report a bank count that passes the existing checks and overflows the array during enumeration.
Engineers running Linux kernels with LJCA device support should check whether their kernel includes this fix; affected versions were not specified.