Zephyr unsupported pin access in GPIO syscalls
zephyrproject zephyr
Affected versions
| Product | Affected | Fixed in |
|---|---|---|
| zephyrproject zephyr |
| No fix yet |
Original description
The GPIO syscall handlers in drivers/gpio/gpio_handlers.c did not validate the pin argument supplied by a user-mode caller. z_vrfy_gpio_pin_configure(), z_vrfy_gpio_pin_get_config() and z_vrfy_gpio_pin_interrupt_configure() verified only the device object (K_SYSCALL_DRIVER_GPIO() / K_SYSCALL_OBJ()) and then passed the caller-supplied gpio_pin_t straight through to z_impl_gpio_pin_*() and on to the driver. The only pin check in include/zephyr/drivers/gpio.h was __ASSERT(gpio_port_pin_is_supported(cfg->port_pin_mask, pin), ...), which compiles to nothing unless CONFIG_ASSERT is enabled, so in a production build no check existed at all.
GPIO drivers use pin as a shift count and as an array index on the documented assumption that it is a pin the controller supports. On STM32, for example, gpio_stm32_pin_interrupt_configure() turns pin into an EXTI line and stm32_gpio_intc_set_irq_callback() writes data->cb[line_num].cb and data->cb[line_num].data into a NUM_EXTI_LINES-entry array (default 16) in drivers/interrupt_controller/intc_gpio_stm32.c, guarded only by a compiled-out __ASSERT_NO_MSG(); the same function then reads exti_irq_table[line_num] and calls irq_enable() on the result. Other controllers index fixed-size per-pin configuration tables the same way — drivers/gpio/gpio_ite_it8xxx2_v2.c reads an MMIO base pointer out of wuc_base[8] with the caller's pin and performs a read-modify-write through it.