Type confusion in Zephyr HL78xx GNSS NMEA driver causes wild-pointer write from GNSS input
zephyrproject zephyr
Affected versions
| Product | Affected | Fixed in |
|---|---|---|
| zephyrproject zephyr |
| No fix yet |
Original description
The Sierra Wireless HL78xx modem GNSS driver (drivers/modem/hl78xx/, later drivers/modem/vendor_standalone/hl78xx/) embeds a generic struct gnss_nmea0183_match_data match_data inside struct hl78xx_gnss_data. The generic NMEA0183 match helper (drivers/gnss/gnss_nmea0183_match.c) requires that context to be the first member because its callbacks cast user_data directly to struct gnss_nmea0183_match_data . In the affected releases match_data was the second member (after const struct device dev), so it sat at a non-zero offset while gnss_nmea0183_match_init() initialized it at the correct address. The registered NMEA handlers instead pass the whole device data object (data->devices.gnss->data, offset 0), producing an offset-shifted type confusion between where state is initialized and where the parse callbacks read and write it.
When NMEA sentences from the GNSS receiver are parsed, the GGA/RMC callbacks write parsed fix data into the wrong location within the struct, and the GSV callback (gnss_nmea0183_match_gsv_callback, active under CONFIG_GNSS_SATELLITES) reads its satellites pointer and bound from the wrong offsets — non-pointer bytes of struct hl78xx_gnss_data — and then writes parsed struct gnss_satellite entries through that bogus pointer. This is a write through an uninitialized/wild pointer with a garbage bound.