DesignWare I2C target driver can be wedged into a permanent stuck state by an on-bus master (DoS)
zephyrproject zephyr
Affected versions
| Product | Affected | Fixed in |
|---|---|---|
| zephyrproject zephyr |
| No fix yet |
Original description
In the Synopsys DesignWare I2C driver (drivers/i2c/i2c_dw.c) operating in target/slave mode, the rx_full interrupt handler gates the write_requested() callback on dw->state != CMD_SEND, and dw->state is only reset to READY on a STOP interrupt. The START_DET interrupt, whose handler in i2c_dw_slave_read_clear_intr_bits() would reset the state on every (re)START, was never added to the enabled interrupt mask in i2c_dw_slave_register(), so that recovery path was dead code.
As a result, if the STOP interrupt is lost (bus glitch/reset, or a concurrent master driving STOP) or the bus master issues a legal WRITE-repeated-START-WRITE sequence with the same direction, the driver remains in CMD_SEND permanently and never invokes write_requested() again for the life of the target.