i2c: rtl9300: ensure data length is within supported range
Linux
Affected versions
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
|
Linux
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
|
In the Linux kernel, the following vulnerability has been resolved:
i2c: rtl9300: ensure data length is within supported range
Add an explicit check for the xfer length to 'rtl9300_i2c_config_xfer' to ensure the data length isn't within the supported range. In particular a data length of 0 is not supported by the hardware and causes unintended or destructive behaviour.
This limitation becomes obvious when looking at the register documentation [1]. 4 bits are reserved for DATA_WIDTH and the value of these 4 bits is used as N + 1, allowing a data length range of 1 <= len <= 16.
Affected by this is the SMBus Quick Operation which works with a data length of 0. Passing 0 as the length causes an underflow of the value due to:
(len - 1) & 0xf
and effectively specifying a transfer length of 16 via the registers. This causes a 16-byte write operation instead of a Quick Write. For example, on SFP modules without write-protected EEPROM this soft-bricks them by overwriting some initial bytes.
For completeness, also add a quirk for the zero length.
From the CVE record · Linux
The Linux kernel's rtl9300 I2C driver does not properly reject zero-length transfers, which the hardware does not support. An SMBus Quick Write with a zero-length transfer can instead become a 16-byte write, potentially overwriting data on devices such as SFP modules with unprotected EEPROM. The input does not specify attacker access, authentication, or user-interaction requirements.
Engineers running Linux kernels with the rtl9300 I2C driver should check their deployments; affected versions are not specified.