ath11k: Change max no of active probe SSID and BSSID to fw capability
Linux
Affected versions
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
|
Linux
| Product | Affected | Fixed in |
|---|---|---|
| Linux Linux |
| No fix yet |
| Linux Linux |
|
|
5.17.145.18.35.19In the Linux kernel, the following vulnerability has been resolved:
ath11k: Change max no of active probe SSID and BSSID to fw capability
The maximum number of SSIDs in a for active probe requests is currently reported as 16 (WLAN_SCAN_PARAMS_MAX_SSID) when registering the driver. The scan_req_params structure only has the capacity to hold 10 SSIDs. This leads to a buffer overflow which can be triggered from wpa_supplicant in userspace. When copying the SSIDs into the scan_req_params structure in the ath11k_mac_op_hw_scan route, it can overwrite the extraie pointer.
Firmware supports 16 ssid * 4 bssid, for each ssid 4 bssid combo probe request will be sent, so totally 64 probe requests supported. So set both max ssid and bssid to 16 and 4 respectively. Remove the redundant macros of ssid and bssid.
Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.7.0.1-01300-QCAHKSWPL_SILICONZ-1
From the CVE record · Linux
The ath11k driver reports support for 16 active-probe SSIDs, but its scan request structure holds only 10. A scan initiated through wpa_supplicant in local userspace can overflow that structure and overwrite a pointer. The input does not specify an authentication or user-interaction requirement.
Engineers running Linux kernels with the ath11k driver should check their installations; affected versions are not specified.